Canopy Lock Installation Guide
The 1 in. .063 white washer is used on the
RV8 and the F1 Rocket only. “NOT USED” on the RV6,7,9 Series
aircraft.
FIRST STEP
Slide the canopy to the desired
position for cockpit venting and mark the position for the hole to be drilled. Drill the
hole using a D drill and supplied drill guide. Ream to ¼ in.
SECOND STEP
Slide canopy forward and close latch.
Install the canopy lock and measure distance from the lock to where the canopy skirt contacts the
slider guide.
THIRD
STEP
Cut the plastic spacer to length using a table
saw.
The white spacer is used when a fully locked canopy is desired. This will allow most canopy covers to fit.
It is suggested that a piece of shrink wrap be installed on the lock to
prevent damage to the paint on the skirt when the vent position is
used.
Canopy Lock $100.00